Mc-techgroup BA-C Operator's manual Manual de usuario descargar pdf (Pagina 13)

Gas sampling and gas conditioning technology 10-1.1.1-ME

13 INITIAL OPERATION

Prior to initial operation, the system and process-specific safety measures must be observed !

The following steps must be carried out prior to initial operation:

 Prior to initial operation, compare the system voltage with the voltage shown on the rating plate;

 Connect the air conditioning unit to the mains;

 Connect status contact ouput, if necessary ;

 Operate the “Power/On” switch (green LED lights).

 Check the nominal temperature of 500°C at the temperature controller (see Figure 2).

 When operational readiness has been reached (about 15 minutes), the 1 lights upin the display.

W A R N I N G !

The air conditioning unit is operated with min. 73 psi and max.

145 psi inlet pressure.

NOTE!

The maximum gas flow is 15Nl/min.

14 SWITCH OFF

NOTE!

The place of installation of the air conditioning unit must be

remain free from frost also during time when the unit is switched

off !

Switch off the device and disconnect the pressure air.

No more particular measures are required for switch off.

15 MAINTENANCE

Before carrying out maintenance work, the system and process-specific safety measures must be

observed!

W A R N I N G !

The air conditioning is operated with max. 145 psi inlet pressure.

High voltage and high pressure. Disconnect the mains plug and

the pressure air inlet before opening the housing!

1 2 ... 8 9 10 11 12 13 14 15 16

Sin comentarios

Mc-techgroup BA-C Operator's manual Manual de usuario Pagina 13