Mc-techgroup ECM-ExII Operator's manual Manual de usuario

Gas sampling and gas conditioning technology 3-3.0EX-ME

10 Gas sampling and gas conditioning technology 3-3.0EX-ME 10.2 OPTIONS FOR BASIC COOLER ECM-EXII Heat exchanger type ECM-1G ECM-1PV ECM-1SS

11 Gas sampling and gas conditioning technology 3-3.0EX-ME The cooler ECM-ExII is equally suitable for wall installation. The depth of the housin

12 Gas sampling and gas conditioning technology 3-3.0EX-ME +5°C Sample OUT Sample IN Condensate OUT Cooling block Figure 3 Schematic dia

13 Gas sampling and gas conditioning technology 3-3.0EX-ME 14 INSTALLATION INSTRUCTIONS The ECM-ExII cooler is suitable for wall mounting. NO

14 Gas sampling and gas conditioning technology 3-3.0EX-ME NOTE! Do not mix up the hose connections; the inlet and outlet connections of

15 Gas sampling and gas conditioning technology 3-3.0EX-ME 15.2 ELECTRICAL CONNECTIONS CARE! When connecting the equipment, please ens

16 Gas sampling and gas conditioning technology 3-3.0EX-ME Figure 5 Electrical sockets alarm contact The connection of the mains respecti

17 Gas sampling and gas conditioning technology 3-3.0EX-ME 17 CLOSING DOWN NOTE! The location for the cooler must remain frost-free, even when

18 Gas sampling and gas conditioning technology 3-3.0EX-ME Replace the heat exchangers as follows:  Dry and clean the push-in opening in th

19 Gas sampling and gas conditioning technology 3-3.0EX-ME 18.3 MAINTENANCE OF THE OPTIONAL MOUNTED PERISTALTIC PUMP(S), TYPE SR25.2 Befo

2 Gas sampling and gas conditioning technology 3-3.0EX-ME Dear customer, we have made up this operating manual in such a way

20 Gas sampling and gas conditioning technology 3-3.0EX-ME  Take away conveying belt  and remove the old hose set  from the guides by t

21 Gas sampling and gas conditioning technology 3-3.0EX-ME 19 OPERATING OF THE BUILT-IN ELECTRONIC TEMPERATURE CONTROLLER NOTE! Only use temp

22 Gas sampling and gas conditioning technology 3-3.0EX-ME 20 TROUBLE SHOOTING The following table should give an overview of possibl

23 Gas sampling and gas conditioning technology 3-3.0EX-ME 21 SPARE PARTS LIST Wear, tear and replacement part requirements depend on specific o

24 Gas sampling and gas conditioning technology 3-3.0EX-ME 22 APPENDIX  Sample output dew point depending on gas flow rate at sample inlet

25 Gas sampling and gas conditioning technology 3-3.0EX-ME Figure 9 Circuit diagram ECM-ExII

26 Gas sampling and gas conditioning technology 3-3.0EX-ME

27 Gas sampling and gas conditioning technology 3-3.0EX-ME

28 Gas sampling and gas conditioning technology 3-3.0EX-ME

29 Gas sampling and gas conditioning technology 3-3.0EX-ME

3 Gas sampling and gas conditioning technology 3-3.0EX-ME Content 1 General information ...

30 Gas sampling and gas conditioning technology 3-3.0EX-ME

31 Gas sampling and gas conditioning technology 3-3.0EX-ME

32 Gas sampling and gas conditioning technology 3-3.0EX-ME

33 Gas sampling and gas conditioning technology 3-3.0EX-ME

34 Gas sampling and gas conditioning technology 3-3.0EX-ME

35 Gas sampling and gas conditioning technology 3-3.0EX-ME

36 Gas sampling and gas conditioning technology 3-3.0EX-ME

37 Gas sampling and gas conditioning technology 3-3.0EX-ME

38 Gas sampling and gas conditioning technology 3-3.0EX-ME

39 Gas sampling and gas conditioning technology 3-3.0EX-ME

4 Gas sampling and gas conditioning technology 3-3.0EX-ME Head Office M&C TechGroup Germany GmbH  Rehhecke 79  40885 Ratingen  German

5 Gas sampling and gas conditioning technology 3-3.0EX-ME 3 ELECTRICAL STANDARDS The electrical standard of electrical equipment corresponds to

6 Gas sampling and gas conditioning technology 3-3.0EX-ME 5 INFORMATION AND SAFETY INSTRUCTIONS FOR USING THE COOLER IN HAZARDOUS ARE

7 Gas sampling and gas conditioning technology 3-3.0EX-ME 7 USED TERMS AND SIGNAL INDICATIONS DANGER! This means that death, severe phys

8 Gas sampling and gas conditioning technology 3-3.0EX-ME 8 INTRODUCTION The patented M&C ECM-ExII gas cooler unit is always to be i

9 Gas sampling and gas conditioning technology 3-3.0EX-ME The gas to be measured is taken from the ECM-ExII gas cooler  by a gas sample probe 